Updated 2/25/06
AS-04-SPN AutoSpin / Credit-Add / AutoStop BACK
The AS-04-SPN will work on all machines that
use the AS-04 and have 2 coin sensors. See: Credit Table
In addition to the AutoStop and Credit-Add functions, it can add 3 credits and
AutoSpin your machine (and AutoStop)! This is very useful as an "attract
mode" on your machines. I also like to use it for getting new or stingy
machines into BONUS mode, without a lot of work on my part.
The AutoSpin time is adjustable from 5 seconds to 15 minutes.
Unplug machine from the outlet. Open the machine door. Locate the stop board and remove the 30-conductor cable by pressing down on the two cable release levers. (Do not disconnect the other end of the cable from the motherboard.) Plug one end of your existing cable into the AUTOSLOT cable and the other end of the AUTOSLOT cable into the connector on the stop board, making sure the levers latch back into place.
Follow the instructions on www.autoslot.info/credit for information on connecting the credit wires to the coin mechanism. You will also need to attach the “C” wire to spin knob wire that goes low when the knob is pressed.
Operation:
Changing Settings: (Note: buttons must be held down for 2 or more seconds.)
|
BUTTON STATUS |
FUNCTION
|
||
|
● |
|
|
Toggle Auto Stop Mode On/Off |
|
|
● |
|
Toggle Random Mode On/Off |
|
|
|
● |
Add Credits |
|
● |
● |
|
Step AutoSpin Times: 5s,15s,1m,5m,15m |
|
|
● |
● |
Toggle AutoSpin Mode On/Off |
|
● |
|
● |
Toggle Reel-Reel Delay |
|
● |
● |
● |
Restore Defaults |
To turn ON the Auto Stop mode, press and hold the left reel stop button while the reels are stopped. To turn it OFF, simply press and hold the left button again.
Normally, the reels will stop in a Left to Right order. To have the reels stop in a Random order, press and hold the center button. The microcontroller uses a Random Number generator to change the stop order on each spin. Press and hold the center button again to switch back to Left to Right.
To Add Credits, hold down button 3 until credits begin to register. This will simulate up to a maximum of 53 tokens added to the machine (3 for current spin and 50 credits).
Once the spin lever is pushed, the default time that all the reels spin before the first reel stops is 2 seconds.
You can adjust this AutoSpin Delay time from a minimum of 5 seconds to a maximum of 15 minutes. To Step through the AutoSpin Delay Times, press and hold the left and center buttons at the same time. Repeat as needed.
To Toggle the AutoSpin Mode between Off and On, press and hold the center and right buttons at the same time.
The default time between one reel stopping and the next is ˝ second. This Reel-Reel Delay time can be changed to 1 second by pressing down the left and right buttons at the same time. Press and hold these buttons again to switch the machine back to ˝ second delay.
You can Restore the Default settings (Auto Stop On; Random Off; AutoSpin On; 5 sec AutoSpin Delay; 1 second Reel-Reel Stop Delay) by pressing down all three buttons at the same time.
*******If the AutoStop board doesn’t seem to be working properly:*******
Hold down all three buttons for about 10 seconds after the machine is on. This will restore the default settings and will get the correct spin logic.
*****************************************************************