AS-NET Credit-Add / AutoStop  for NET machines                 BACK

The AS-NET will perform the AutoStop and credit-add functions for NET machines that have connectors as shown below, (such as Super BlackJack).  (Since NET machines do not use a standard removable stop board, the regular cable model AutoStops cannot be used.)

Installation:

Turn off power to machine.  Using a pair of pliers, attach the T-taps to the appropriate wires and plug in the spade connectors from the AS-NET as shown in the picture and chart below.

 *  Place two T-tap connectors on each of the machine’s coin sensor wires and cut the wire between them.

Operation:

Changing Settings:  (Note: buttons must be held down for 2 or more seconds.)

To turn ON the Auto Stop mode, press and hold the left reel stop button while the reels are stopped.  To turn it OFF, simply press and hold the left button again.

Normally, the reels will stop in a Left to Right order.  To have the reels stop in a Random order, press and hold the center button.   Press and hold the center button again to switch back to Left to Right.

Once the spin lever is pushed, the default time that all the reels spin before the first reel stops is 2 seconds.  You can adjust this Spin-Stop Delay time from a minimum of 1 second to a maximum of 3 seconds.   To Decrease the Spin-Stop Delay by ½ second, press and hold the left and center buttons at the same time.  To Increase the Spin-Stop Delay by ½ second, press and hold the center and right buttons at the same time.  Repeat as needed.

To Add Credits, press and hold the right button (about 2 seconds) until credits start to register.  It will automatically add up to 53 tokens.

The default time between one reel stopping and the next is ½ second.  This Reel-Reel Delay time can be changed to 1 second by pressing down the left and right buttons at the same time.  Press and hold these buttons again to switch the machine back to ½ second delay.

You can Restore the Default settings (Auto Stop On; Random Off; 2 sec Spin-Stop Delay; 1 second Reel-Reel Stop Delay) by pressing down all three buttons at the same time.

Note:

Wait at least 3 seconds after powering up the slot machine before operating it.  The AUTOSLOT Auto Stop uses this time to determine the input logic needed. 

●

Toggle Reel-Reel Delay between ½  and 1 sec

●

●

●

Restore Defaults

To turn ON the Auto Stop mode, press and hold the left reel stop button while the reels are stopped.  To turn it OFF, simply press and hold the left button again.

Normally, the reels will stop in a Left to Right order.  To have the reels stop in a Random order, press and hold the center button.   Press and hold the center button again to switch back to Left to Right.

Once the spin lever is pushed, the default time that all the reels spin before the first reel stops is 2 seconds.  You can adjust this Spin-Stop Delay time from a minimum of 1 second to a maximum of 3 seconds.   To Decrease the Spin-Stop Delay by ½ second, press and hold the left and center buttons at the same time.  To Increase the Spin-Stop Delay by ½ second, press and hold the center and right buttons at the same time.  Repeat as needed.

To Add Credits, press and hold the right button (about 2 seconds) until credits start to register.  It will automatically add up to 53 tokens.

The default time between one reel stopping and the next is ½ second.  This Reel-Reel Delay time can be changed to 1 second by pressing down the left and right buttons at the same time.  Press and hold these buttons again to switch the machine back to ½ second delay.

You can Restore the Default settings (Auto Stop On; Random Off; 2 sec Spin-Stop Delay; 1 second Reel-Reel Stop Delay) by pressing down all three buttons at the same time.

Note:

Wait at least 3 seconds after powering up the slot machine before operating it.  The AUTOSLOT Auto Stop uses this time to determine the input logic needed.